 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Warning, offensive carpet and wiring. Wiring will be sorted. Carpet... not. Also ignore the Honeywell fans, threy are now redundant and going to be redeployed.
Got the Vacmaster fan from Amazon warehouse reduced and boy... they can move some air! I know a few of the guys use them on here for Zwift etc. They really are good.
Wanted to make the "beam" of very focused air vertical though, ala Wahoo Headwind. Sideways on a lot of the air is wasted imo.
So...
Gaffer tape.
Corrugated cardboard.
And...
Now I know some of you guys would 3D print the extending leg and pivoting strut but still.
You need to extend one foot or when you tilt the fan its unstable and shifts to one side. Cardboard rolled up and taped on.
The pivoting leg allows angle adjustment of airflow. Just pivots on a bike made of gaffer tape. Inside out tape on the foot to allow grip on floor.
It's fitted into a remote control plug along with other fan above the table.
I'm now looking at a bodge to remotely control the 3 speeds of the fan. That will need a bamboo cane, a small universal joint... and gaffer tape.😜