 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
They say it works.
Has anyone tried it?
If so, does it function ok?
As far as I am aware there aren't any issues.
What tyres are you running? The only issue I can think of is wide tyres catching the mech. There are a few on the owners group who have them with front mechs and I don't recall hearing any issues.
I tried it (XT mech). It worked fine. But eventually I took it off again to make way for a dropper post lever.
I ran my Slackline NextGen with a front derailleur no problems, Sram X5 dual pull thing.
Sherpa ti here, with a 3x9 drivetrain on it! You'll need a top pull high mount front derailleur to clear the rear tyre (very short chainstay and big wheel), It works perfectly, and I've squeezed a dropper remote onto the LHS of the bar with some custom mount fettling.
Ta.
I haven't bought the frame yet!! I wanted to confirm there were no issues before I went ahead.
The tyres will either be Conti Mountain King 2.4 swapped over from an old bike, or preferably the slightly smaller Michelin Wild AM which I've been using on another bike recently and prefer.
Bramblesummer...do you mean a bottom swing mech...with the band sitting higher on the seat tube and the mech swinging below?
Sideswing FTW !?!
Sorry, idiot moment, bottom swing is correct. Clamp band is the highest point.
Thank you kindly
https://www.flickr.com/photos/77564901@N06/30550220472/in/datetaken/
Top pull on mine. If going B+ make sure you get a boost crank if you want to access your bottom two gears... 😳
Hopefully page links (can't imbed photo on the iPad...)
Nice- ta