 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Bike Forum
1
Posts
2
Users
0
Reactions
48
Views
Topic starter
Want to pull out this internal run on a Whyte M-109
[IMG] 
[/IMG]
[IMG] 
[/IMG]
It leads to the front mech and I have the stuff for 1x10.
Do I pull out the rubber grommets too and then black patch and add some copter tape over to seal the hole? I know it's an ideal dropper post route - but I don't want to run one.
Also to rerun the cable - I believe there to be no internal sleeve, so how do I get a cable back through, when I change my mind next week?
Only took me 3 hours to go tubless with Packing adhesive tape and valves! At one point it looked worse than the "badger" pic.
Wally.
Posted : 25/01/2015 7:17 pm
Cotton thread and a vac, when you want to go back.
Posted : 25/01/2015 7:22 pm