 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Evenin' all,
I'm running the On-One Carbon Fatty fork on my Fatty trail. Thinking (just thinking!) of getting a Bluto.
I believe the Bluto runs a 15x150 axle - my wheels are QR x 150, though the end caps of the hubs are removable and there's certainly a 15mm bore through the hub.
On One have no hub 'conversion' ends on their site, but I'm sure they are generic (re-branded) hubs and the end caps needed must be available
Anyone know where I can get them? I can post a pic and dimensions of the caps if required.
Also thoughts from other fatsters on the Bluto?
I'm looking to add the Bluto for trail centre riding (Labyrinth at Swinley nearly busted my arms on the rigid). But I'll still run rigid for much of my summer riding (Ridgeway and similar)
(No, I haven't contacted On-One, but I think I'll get a more helpful response here)
If you're running the on one fork your wheels are 135qr and have rear wheel spacing on the disc. So no go with Bluto.
Apparently the on one fatty hubs are made by chosen and are also the same as the 9zero7 hubs.
Might be of some help..
http://forums.mtbr.com/fat-bikes/chosen-fat-bike-hubs-941169.html
If you find the hub width adapters, this should allow your RDS hub to fit the FDS Bluto.
Still using one to fit my FatNotFat wheels on the default Wazoo fork, On One carbon RDS fork still gathering dust! 😯 😆