 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
I have a couple of issues I need advice on.
Noisy Ibis: My 1st gen Mojo makes a weird 'chung' noise when I land heavily. Sounds like a disk rotor or spoke issue. Spokes are tight and rotor looks well clear of the calliper.
Hub Issue: So, in an attempt to fix this I bought a 10mm bolt in axel for my Pro 2 to try and stiffen up the rear end, replacing the QR. Unfortunately the axel only fits a Pro 4 (see pic) as the shaft is too wide to fit into the cassette.
Any thoughts on how to solve this? Thanks!
<b> https://tinyurl.com/y79tluz5</b>
Also struggling to get the picture to show!!
You'll need a Pro2 Evo Freehub and possibly hub shell bearings, or get the proper Pro2 non-Evo 10mm axle. HUB216 is the 10mm axle for Pro2.
Thanks, though it looks like the HUB216 is discontinued and as rare as rocking horse shit.
OP - Think this the Axle you're looking for
https://www.sjscycles.co.uk/hub-spares/hope-pro-2-rear-axle-10mm-thro-135mm-hub216s/
I think i might've hit gold here;
https://www.sjscycles.co.uk/hub-spares/hope-pro-2-rear-boltin-conversion-kit-10mm-hub224/