My free hub has gon...
 

  You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more

[Closed] My free hub has gone silent....

9 Posts
8 Users
0 Reactions
440 Views
Posts: 2126
Full Member
Topic starter
 

So I cleaned my  bike the other day and decided to give the free hub a once over as its never been touched in the 2 years i have had the bike.  Bog standard dt swiss jobbie that came on the bike. Removed the free hub, cleaned the bearing and  put a wee bit of grease on the bearing and  pawls. Trouble is the lovely clicky sound is gone and the rear runs silent now. Should you not grease the pawls? Runs fine otherwise.


 
Posted : 10/07/2019 9:09 pm
Posts: 9093
Full Member
 

Probably too much grease.


 
Posted : 10/07/2019 9:29 pm
Posts: 16216
Full Member
 

Tell everyone you've got the new expensive shim freehub?😉


 
Posted : 10/07/2019 9:43 pm
Posts: 923
Full Member
 

It should thin out if you ride it enough 😉

On a similar note,  steel Pro 2 Evo hubs are considerably quieter than the aluminium ones


 
Posted : 10/07/2019 10:01 pm
 Bez
Posts: 7371
Full Member
 

DT Swiss hubs don't have pawls, at least none of the ones I've seen do.

You shouldn't normally grease pawls; they like a nice thin lube. DT ratchets do use grease, but a thinner grease than most. At least as far as I can tell.


 
Posted : 10/07/2019 10:05 pm
Posts: 6581
Free Member
 

DT Swiss hubs don’t have pawls, at least none of the ones I’ve seen do.

The cheaper ones do.


 
Posted : 10/07/2019 10:10 pm
Posts: 2126
Full Member
Topic starter
 

I dont know of its pawls or ratchet tbh. I greased the 3 sticky out bits on the back of free hub that engage/drive the wheel, if that makes sense. Guess i will just leave it rather than strip it and wipe it all off, if its not going to do any harm. Might clean it up and oil it next time i take it apart.


 
Posted : 10/07/2019 10:35 pm
Posts: 5661
Full Member
 

Yeah that's pawls, a ratchet will have 2 rings.

My Novatec hub has also gone almost silent, I stripped and cleaned it a few months ago as it was creaking, pretty sure I just lubed it with some chain lube though.


 
Posted : 10/07/2019 10:58 pm
 Bez
Posts: 7371
Full Member
 

The cheaper ones do.

Ah, I did wonder.

Right then. Pawls, I'd probably clean them up and pop some light lube in there, but I may be paranoid having once gone over the bars when a freewheel failed to engage at an inopportune moment.


 
Posted : 10/07/2019 11:02 pm
Posts: 21461
Full Member
 

Grease is fine. It's a question of how much and how thick. Back pedal the bike and see if the top of the chain goes slack, if it does, there's probably a bit too much in there. This would be more noticeable in the colder months but will most likely be fine this time of year. You'll find the noise will most likely be back in a few rides.


 
Posted : 11/07/2019 3:24 am

6 DAYS LEFT
We are currently at 95% of our target!