 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Topic starter
Anyone own the tools, care to share the dimensions?
I dont mind spending 20 quid for them from crc, but I need them for 3 different wheelsets... gets a bit pricey then.
I can get the engineer at work to turn them out for me.
Just need the dimensions...
Front and rear,
Pro 2
Pro 2 Evo
Sport hubs
Posted : 16/04/2015 1:11 pm
Hopetech's website gives dimensions for some of the modern hub bearings, and bearing codes that you can work from otherwise. Remember to factor in clearance so they don't get stuck on axles/in hub shells, and enough length to extend past the end of the axles when fully seated.
Posted : 16/04/2015 3:25 pm