Kona Unit vs Charge...
 

  You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more

[Closed] Kona Unit vs Charge Cooker Single Speed

8 Posts
5 Users
0 Reactions
165 Views
Posts: 853
Free Member
Topic starter
 

Considering a not too expensive single speed rigid 29er... Any thoughts on the above bikes or any other suggestions?


 
Posted : 15/10/2013 7:40 pm
Posts: 10942
Free Member
 

Check out their top tube lengths, i think that the Kona will be longer than the Charge, this may help you decide depending on fit.


 
Posted : 15/10/2013 7:53 pm
Posts: 10942
Free Member
 

Cannondale? in Alu with a S T I F F fork?


 
Posted : 15/10/2013 7:54 pm
Posts: 110
Free Member
 

One thing that puts me off the charge is the eccentric bottom bracket. Apparently they require a bit more maintenance, and look quite complex which I think goes against the simple ethos of the rigid/ss, so I think I would prefer horizontal drop outs. I do however have a cooker and really like it (but it's not SS but looking to make it rigid!)


 
Posted : 15/10/2013 8:05 pm
Posts: 4331
Full Member
 

That's one of the reasons I went for the Unit, the sliding drop outs are a breeze to adjust.

Also the Unit can run a suspension fork while the Charge won't IIRC, makes the Unit a bit more versatile IMO


 
Posted : 15/10/2013 8:31 pm
Posts: 853
Free Member
Topic starter
 

Ok, thanks for your thoughts chaps... I'm coming round to the opinion that whilst the Charge is prettier I prefer the Kona...


 
Posted : 15/10/2013 8:51 pm
Posts: 0
 

I prefer slider dropouts to eccentric bottom brackets, have run both, the sliders are a lot less maintenance.


 
Posted : 15/10/2013 8:54 pm
Posts: 110
Free Member
 

I don't think either really represent good value for money, e.g. avid mechanical brakes on the unit. I might be tempted to look at the on-one inbred ss, and the carbon fork.


 
Posted : 15/10/2013 8:58 pm
Posts: 4331
Full Member
 

TBH most bikes don't represent good value for money these days! I removed the BB7s and sold them on, just put some Elixir 5s on.

I considered an Inbred, but had heard that they felt a bit dead, and I didn't want slotted dropouts if possible. Sliding dropouts offer easier wheel removal.


 
Posted : 16/10/2013 7:26 am

6 DAYS LEFT
We are currently at 95% of our target!