 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Wash out an xtr m970 shifter with a good solvent and then re-apply a wee bit of spray grease to it.
This sort of stuff.
[url= http://www.ebay.co.uk/itm/WD-40-High-Performance-White-Lithium-Grease-Aerosol-Lubricant-Spray-WD44391-/281398139555?pt=LH_DefaultDomain_3&hash=item4184a2daa3 ]link[/url]
Or do you need to use a light oil.
My front one is sticking on release.
Cheers all..
That problem's generally caused by a small pawl sticking on it's shaft (probably dried up grease), usually easily cured by removing the cover, applying a drip of GT85 on the shaft, and working the pawl free with a little screwdriver or similar (random spraying isn't as likely to go where it's needed, and doesn't adress the need to work the pawl free).
If this makes any sense coatesy.
Iv,e had it opened up a couple of times and it works great with only a wee bit on tension and the pawl is free.Soon a you load it up with a chunk of pressure(shifted onto mid front) when you go to release it there's two clicks.First one is a small click and nothing happens.Then you really have to push it to get to drop a cog...AAARRRR.Pain in the arse...
I usually use WD-40 to clean out sticking shifters. Its much less likely to damage plastic or rubber than something like carb cleaner. I then use a silicone spray to relube.
Just tried that Joe.Still the same.I think some wee bit inside is well and truly buggered.Time for the bin.