You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
A job I’ve been putting off for a long time is taking apart and inspecting a couple of Hope hubs. With the bikes not currently being ridden now seems the time.
My Google fu is weak at the moment and I’m not obviously seeing what tools I would need for Pro2, Fatsno and Pro 2 Evo. I think all of these use the same bearings and free hub so should be the same kit. I’d want to do front, rear and free hubs.
I’m going to leave my Pro 4s for now.
Yes I know I could use sockets etc but if there was one thing I would go back and repeatedly change is to have the right tools the first time around!
All help much appreciated 😀
Pro 4 and Pro 2Evo are the same tools, I think Pro 2 uses a slightly different set. Not sure on the Fatsno, suppose it depends which series it's from.
Pro 2 - https://www.stifmtb.com/products/hope-pro-2-hub-complete-tool-kit
Pro2 Evo - https://www.stifmtb.com/products/hope-pro2-evo-tool-kit-tool-kit
I found this document on Hope's site - https://www.hopetech.com/_repository/1/documents/RearHubServiceTools.pdf