 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Topic starter
ok I know its a dum question but dose anybody know how to remove a lefty hub end cap I need to change my front wheel bearings. And I need to strip my rear code hub bearings seem tight and would it be possible to change it from a standerd qr to something stiffer
Posted : 30/12/2013 2:51 pm
You need a pin spanner.
[IMG] 
[/IMG]
Posted : 30/12/2013 2:54 pm
Think the front hub cap is a left hand thread (turn clockwise to unscrew)
Bolt
Posted : 30/12/2013 2:58 pm
You're welcome to borrow my pin spanner if you are near Bath or Cardiff, otherwise they are quite cheap on Wiggle etc
Posted : 30/12/2013 3:12 pm
Topic starter
Thanks all iv made a spanner so bearings out how just the back wheel to look at
Posted : 30/12/2013 3:47 pm
I need to strip my rear code hub bearings seem tight and would it be possible to change it from a standard qr to something stiffer
Code or Coda? I doubt you'll be updating the axle on a coda hub....
Posted : 30/12/2013 3:56 pm