 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Just shortened my hoses and unable to straighten the cables after I have tightened them up Hope website is very unclear!
[url= http://farm9.staticflickr.com/8433/7804358168_bd2aa0cf31.jp g" target="_blank">
[url= http://www.flickr.com/photos/nzrich/7804358168/ ]P8171596[/url] by [url= http://www.flickr.com/people/nzrich/ ]Richard Munro[/url], on Flickr
Ta Rich
Loosen the nut off at the lever end, twist the hoses until they are straight, keeping them in that position tighten the nut up
Hey presto all will be fine
Or remove levers from bars, twirl levers til straight then reinstall.
Wont work if they're only half a turn twisted etc.
Really?Just shortened my hoses
Are you planning on barspinning or tailwhipping it?
If you have bleed them then remove the calliper or lever & untwist as said, but I just removed the banjo bolt & twisted it back before bleeding as it was the quickest way.
PS I did my rear today & although I thought i was keeping an eye on the level whilst bleeding it I gave it one to many pumps & went below the required fluid level & I had to start all over again, silly me! 😉
PS, are your handlebars carbon fibre or pig iron, it's not really clear?
😉
I did my rear today & although I thought i was keeping an eye on the level whilst bleeding it I gave it one to many pumps & went below the required fluid level & I had to start all over again
😯 ouch..!
fnarr fnarr
carbon fibre or pig iron, in my haste to put the bike together I have just noticed that they are not as they should be, they should say Ritchey superlogic on one side I think I have been done!!!!
Dodgy ebay buy that will teach me.
Watch from 1.30
Postman in mechanical numpty shocker. 😀