You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
Bike Forum
2
Posts
2
Users
0
Reactions
61
Views
Topic starter
Ive just done the bearings for the first time on my spline 1 hubs, it appears there is a bit of a knack to getting the seal in that goes on the outside of the hub shell.
I thaught i had it in, but now she drags.....
Any way of doing it without a £200 tool set?
Posted : 14/04/2016 9:33 pm
Yup- take the axle out and use the freehub to press it in- naturally it fits perfectly into the seal (the tool is essentially the same thing, just slightly easier to use)
Posted : 14/04/2016 9:36 pm
Topic starter
Ta! (Why didnt i think of that!! ) 🙂
Posted : 14/04/2016 10:42 pm