 You don't need to be an 'investor' to invest in Singletrack: 6 days left: 95% of target - Find out more
hi - just curious before i start spacing and bodging...
i was running Cannondale brakes - post mount 180 front, 160 rear with adapters
went to change for some Sram Guide REs that were on my other bike - also PM and same rotors - when i attached to the adapters they are fowling the rotor
is this pretty common - have i again assumed there would be some standard here in the bike industry that doesn't exist and i will have to space these out
This tech doc suggests a configuration - but at a glance this won't fix my problem as the space is required between the adapter and the brake unit
cheers for any pearls of wisdom
The adapters are fouling the rotors?
Pics would help
Put washers under the caliper to move it out a bit. I have the correct mounts on my bike but needed about 1mm to stop the outer edge of the rotor touching the caliper.