Things I’d quite like the bike industry to stop doing now please

Getting a few things off my mountain biking chest.

Sometimes it’s good to moan. It can help get rid of frustrations. A problem shared is a problem halved and all that. Clear the air and move on.

With that in mind, these are the 10 main things that have been bugging me with bikes for the past few years.

Semi-lightheartedly, here goes nothing…

Carbon (apart from rims)

Let’s kick things off with a biggie. Aside from the ecological argument (that I don’t want to get sidetracked by), I just don’t think carbon is worth the money. The amount of extra £-pounds you have to spend to save one or two lb-pounds is faintly outrageous. Arguably most of that weight saving is due to the bike industry seemingly having given up on even trying to make metal bikes light(er), especially North American brands. And a lot of the time I think it’s a worse performing material than metal. The one exception is wheel rims. Carbon rims can be the best rims available. Still loads of money, mind.

High-set helmet peaks

I’m going to pin this one on Specialized. Although other brands are hopping on board this aesthetic, I think Spesh was the first to bring out helmets with peaks set bizarrely far-too-high. High to the point of actually being pointless. Even if you don’t live anywhere that sunny, these high peaks now make dusk rides an exercise in squinting and, quite frankly, dangerous.

Thru-headset anything

Yep, the classic. People may be bored of moaning about thru-headset cable routing but we need to keep up the pressure. Not only does it add complexity and cost to routing service jobs, it doesn’t even look better than regular routing. It’s a disease that’s drifted over from dropbar bikes and it can drift off back there thanks.

Torx bolts

Is it just me, or are torx bolts more prone to rounding out than Allen key bolts? Especially on items that aren’t disc rotor bolts. Any test bike from torx-tastic Scott, for example, usually ends up heading back post-test period with all of the torx bolts looking scratty and mashed. Hex FTW.

Disc mounts on chainstays

Am not exactly sure if brands are putting calipers on the chain stay for suspension-v-braking reasons but I am sure that such a location makes it much more difficult to get at the caliper mount bolts, especially with a multi-tool. And as for the introduction of the patently awful flat-mount standard coming in from roadie world… No. Just no. Can’t we just bring back I.S.? That was clearly superior.

Tokenistic adjustments

One reason why I don’t pick on brands that don’t offer proportional chainstays or flipchips, is because the brands that do offer these things very rarely do it to a sufficient degree. 11mm difference in chain stay length between Small and XX-Large? 0.5° change in geometry via a flipchip? Hardly worth it. If you’re going to market sizing/adjustments, at least make it justifiable.

Curvy rates

Whether this is suspension frame leverage or air springs, I rarely get along with curves that aren’t consistent. I can get them to function okay but in a world where most riders (understandably) don’t want to spend hours and hours setting up a pushbike, these curves are often a recipe for extremely poor bike setup and thus handling. The marketing idea of ‘supple at sag, rampy at the end’ is not what a lot of riders end up sat on.

Silicone grippers

Helmets. Knee pads. Liner shorts. Any of these that have silicone grippers frequently get on my wick. Sometime literally. Essentially using hot glue to keep cycling apparel in place. Ugh.

Car industry aping

All these ‘Works’ bikes. Or eebs with stronger motors in the top tier models. Feels very Beemer M Series. Naff.

And finally…

The tenth slot is open to you. Add your suggestions below!